Lexmark X95 series - Sensor (ADF Scan Width 2) Static Jam

2-162 Service Manual
7558-xxx
Go Back
Previous
Next
288.01 Sensor (ADF scan width 2) static jam
2
Check the sensor (ADF scan
width 1) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch ADF/SCANNER
SENSOR TESTS.
4. Touch Sensor (ADF scan
width 1).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 4. Go to step 3.
3
Check the sensor (ADF scan
width 1) for proper connection.
Is the above component
properly connected?
Replace the sensor (ADF scan
width 1). Go to “Sensor (ADF
scan width 1) removal” on
page 4-251.
Replace the connections.
4
Place an undamaged document
in the ADF, and perform an ADF
test.
Does the error remain?
Replace the ADF controller
PCBA. Go to “ADF controller
PCBA removal” on page 4-203.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media or media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the sensor (ADF scan
width 2) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch ADF/SCANNER
SENSOR TESTS.
4. Touch Sensor (ADF scan
width 2).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 4. Go to step 3.
3
Check the sensor (ADF scan
width 2) for proper connection.
Is the above component
properly connected?
Replace the sensor (ADF scan
width 2). Go to “Sensor (ADF
scan width 2) removal” on
page 4-254.
Replace the connections.
Step Action and questions Yes No