Lexmark X95 series - Lubrication Specifications

Preventive maintenance 6-3
7558-xxx
Go Back
Previous
Next
Lubrication specifications
Lubricate only when parts are replaced or as needed, not on a scheduled basis. Use of lubricants other than
those specified can cause premature failure. Some unauthorized lubricants may chemically attack
polycarbonate parts. Use IBM no. 10 oil, P/N 1280443 (Approved equivalents: Mobil DTE27, Shell Tellus 100,
Fuchs Renolin MR30), IBM no. 23 grease (Approved equivalent Shell Darina 1), and grease, P/N 99A0394 to
lubricate appropriate areas. Use Nyogel type 774 to lubricate the Fuser Drive Assembly and Nyogel 744 to
lubricate the ITU and Cartridge Drive assemblies.
ADF feedout roller Inspect Replace Water or alcohol
ADF exit roller assembly Clean Water or alcohol
ADF transport roll assembly Clean Water or alcohol
Lexmark X950, X952, X954
EVERY SERVICE
CALL
EVERY 200K NOTES