Repair information 4-219
7558-xxx
4. Disconnect the cable (B).
Note: When removing the ADF registration motor, the drive belt (C) will become detached.
5. Remove the ADF registration motor.
Reinstallation note: To correctly set the ADF registration motor belt drive tension, install the ADF registration
motor and the ADF registration motor tension spring before completely tightening the two screws.
ADF right hinge removal
1. Remove the ADF from the machine. See “Automatic document feeder (ADF) assembly removal” on
page 4-227.
2. Remove the ADF rear cover. See “ADF rear cover removal” on page 4-218.
To Next Page
Loading...
