Lexmark X95 series - Color Trapping; Disable Scanner; Disk Encryption; Energy Conserve

Diagnostic aids 3-9
7558-xxx
Go Back
Previous
Next
Color Trapping
Color trapping is used to compensate for mechanical misregistration in the printer. When small black text or fine
black lines are being rendered, the printer checks to see if they are being rendered on top of a colored
background. Rather than remove the color from beneath the black content, the printer leaves the color around
the edge of the text or line. In this way, the "hole" in the colored region is reduced in size which prevents the
characteristic "white gap" that is caused by misregistration.
The values 1 through 5 indicate the amount of color that will remain beneath the black content. The more
inaccurate the registration setting, the higher this setting will need to be adjusted.
To change this setting:
1. From the Configuration Menu, navigate to Color Trapping.
2. Touch or to change the value.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Disable Scanner
With this setting, the user can choose to disable the entire scanner or only the ADF portion of it. In this way, an
AIO can continue to function as a “print only” device even when its scanner is malfunctioning.
To change this setting:
1. From the Configuration Menu, navigate to Disable Scanner.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Disk Encryption
This setting controls whether the device encrypts the information that it writes to its hard disk (when installed).
To change this setting:
1. From the Configuration Menu, navigate to Disk Encryption.
2. Select Disable or Enable.
Energy Conserve
This setting affects the values that display in the “Sleep Mode” setting. With Energy Conserve set to Off, this
menu displays Disabled which, when selected, deactivates the Sleep feature. When Energy Conserve is set to
On, Disabled does not appear in the Sleep Mode menu.
To change this setting:
1. From the Configuration Menu, navigate to Energy Conserve.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Envelope Prompts
This setting controls the input source to which a device will direct an envelope change prompt. The device
displays envelope prompts based on the size of the envelope requested by the user, not on the envelope type.