Lexmark X95 series - Finisher PCBA Removal

Repair information 4-353
7558-xxx
Go Back
Previous
Next
Reinstallation notes:
•
Make sure the flat spot on the media entrance roll assembly (H) is installed to the rear.
• When replacing the media entrance roll assembly (H), do not touch the rubber surface.
• The tension of the belt (entrance/paddle) (E) is automatically adjusted to the force of the spring attached to
the belt tensioner bracket (D).
• Tighten the two screws in the order shown.
Finisher PCBA removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
2. Remove the rear lower cover. See “Upper media bin front cover removal” on page 4-423.
3. Loosen the four screws securing the plate (A) to the finisher.
4. Move the plate (A) to the right and outward.
5. Remove the plate (A).
A
Rear