Lexmark X95 series - Fuser Driver Communication Failure; Fuser Driver Freeze Failure

Diagnostic information 2-61
7558-xxx
Go Back
Previous
Next
126.03 Fuser driver communication failure
126.04 Fuser driver freeze failure
3
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Does the error continue?
Replace the fuser driver PCBA.
Go to “Fuser driver PCBA
removal” on page 4-90.
Problem resolved
Step Action and questions Yes No
1 Remove the sub LVPS PCBA. Go
to “Sub LVPS PCBA removal”
on page 4-165.
Check the fuser driver PCBA.
Is the above component
properly connected?
Go to step 2. Replace the connections.
2
Replace the fuser driver PCBA.
Go to “Fuser driver PCBA
removal” on page 4-90.
Does the error remain?
Go to step 3. Problem resolved
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Remove the sub LVPS PCBA. Go
to “Sub LVPS PCBA removal”
on page 4-165.
Check the fuser driver PCBA.
Is the above component
properly connected?
Go to step 2. Replace the connections.
2
Replace the fuser driver PCBA.
Go to “Fuser driver PCBA
removal” on page 4-90.
Does the error remain?
Go to step 3. Problem resolved
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No