Lexmark X95 series - Sensor (Bridge Media Exit) Removal

4-314 Service Manual
7558-xxx
Go Back
Previous
Next
6. Disconnect the cable (C) from the sensor (bridge media entrance).
7. Remove the sensor (bridge media entrance).
Sensor (bridge media exit) removal
1. Remove the bridge unit assembly. See “Bridge unit assembly removal” on page 4-305.
2. Remove the bridge de-curler top cover. See “Bridge decurler top cover removal” on page 4-302.
3. Remove the three screws (A) securing the long metal bracket to the machine.
Note: When detaching the long metal bracket, you do not have to remove the harness from the clamps.