Lexmark X95 series - Communication Error with Booklet Controller Card Assembly

Diagnostic information 2-209
7558-xxx
Go Back
Previous
Next
381.41 Communication error with booklet controller card assembly
4
Check the sensor (booklet
compiler media entrance) for
proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (booklet
compiler media present).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 6. Go to step 5.
5
Is the sensor (booklet compiler
media entrance) properly
connected?
Replace the sensor (booklet
compiler media entrance). Go to
“Sensor (booklet compiler
media entrance) removal” on
page 4-382.
Replace the connection.
6
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the booklet controller
card assembly. Go to “Booklet
controller card assembly
removal” on page 4-322.
Problem resolved
7
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the finisher controller
PCBA. Go to “Finisher PCBA
removal” on page 4-353.
Problem resolved
Step Action and questions Yes No
1 Check the booklet controller card
assembly and the finisher
controller card assembly for
proper connection.
Is the above component
properly connected?
Go to step 2. Replace the connection.
2
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the booklet controller
card assembly. Go to “Booklet
controller card assembly
removal” on page 4-322.
Problem resolved
3
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the finisher controller
PCBA. Go to “Finisher PCBA
removal” on page 4-353.
Problem resolved
Step Action and questions Yes No