Lexmark X95 series - Sensor (Media Out) Removal

4-156 Service Manual
7558-xxx
Go Back
Previous
Next
3. Disconnect the cable (B).
4. Remove the sensor (media on belt).
Sensor (media out) removal
1. Remove the appropriate feeder unit. See “Printer tray 1 feeder removal” on page 4-144, “Tray module
media feeder removal” on page 4-281, “TTM tray 4 media feeder removal” on page 4-294, or “TTM
tray 3 feeder removal” on page 4-290.
2. Remove the media out actuator. See “Media out actuator removal” on page 4-123.
3. Release the tab (A) securing the sensor (media out) to the assembly.
4. Remove the sensor (media out).