4-416 Service Manual
7558-xxx
• Tighten the two screws in the order shown.
Stepper motor (entrance/paddle) and belt (entrance/paddle) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
2. Loosen the two screws securing the belt tensioner bracket (A) to the finisher and move upward, as shown.
3. Remove the belt (entrance/paddle) (B) from the stepper motor (entrance/paddle) (C).
4. Disconnect the connector from the stepper motor (entrance/paddle) (C).
To Next Page
Loading...
