Lexmark X95 series - Page 893

Repair information 4-415
7558-xxx
Go Back
Previous
Next
5. Remove the belt (buffer/transport) (D) from the stepper motor (buffer/transport).
6. Disconnect the connector from the stepper motor (buffer/transport).
7. Remove the two screws securing the bracket (E) to the finisher.
8. Remove the bracket.
9. Remove the two screws securing the stepper motor (buffer/transport) to the bracket.
10. Remove the stepper motor (buffer/transport).
11. Remove the belt (buffer/transport) (D).
Reinstallation notes:
•
The tension of the belt (buffer/transport) (D) is automatically adjusted by the force of the spring attached to
the belt tensioner bracket (C).
A
D
C
C
Second
First
Connector