Lexmark X95 series - Erase All Information on Disk; Exit Tray 2; Factory Defaults; Fax Low Power Support

3-10 Service Manual
7558-xxx
Go Back
Previous
Next
To change this setting:
1. From the Configuration Menu, navigate to Envelope Prompts.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Erase all Information on Disk
To run this operation:
1. From the Configuration Menu, navigate to Erase all Information on Disk.
2. Touch Single Pass Erase or Multiple Pass Erase.
Exit Tray 2
To change this setting:
1. From the Configuration Menu, navigate to Exit Tray 2.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Factory Defaults
Warning: This operation cannot be undone.
This setting enables a user to restore all of the device’s settings to either the network settings (on network
models only) or to the base device settings.
To restore the Factory Default settings:
1. From the Configuration Menu, navigate to Factory Defaults.
2. Touch Restore Base to restore all non-critical base printer NVRAM settings.
3. Touch Restore STD Net to restore all network NVRAM settings.
4. Touch Restore LES to remove all Lexmark Embedded Solution applications.
After this setting is changed, the device automatically performs a POR, and restores the appropriate settings to
their factory default values.
Fax Low Power Support
To change this setting:
1. From the Configuration Menu, navigate to Fax Low Power Support.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.