Lexmark X95 series - Operator Panel Assembly Removal

Repair information 4-129
7558-xxx
Go Back
Previous
Next
6. Remove the two screws (C).
7. Remove the MPF tray feeder.
Operator panel assembly removal
Warning: If you are replacing the operator panel in addition to the RIP PCBA or the operator panel PCBA, you
must replace one component at a time. After you replace one component, perform a POR on the
device before replacing a second component. If you replace the components simultaneously, the
printer will be rendered inoperable.
1. Remove the operator panel right cover. See “Operator panel right cover removal” on page 4-11.
2. Remove the operator panel left cover. See “Operator panel left cover removal” on page 4-10.
3. Remove the operator panel front cover. See “Operator panel front cover (MFP) removal” on page 4-8.
4. Remove the three screws (A).