Lexmark X95 series - Sensor (Finisher Media Entrance) Late Jam; Sensor (Diverter Gate) Static Jam a (to Stacker Bin)

2-216 Service Manual
7558-xxx
Go Back
Previous
Next
481.03 Sensor (finisher media entrance) late jam
482.01 Sensor (diverter gate) static jam A (to stacker bin)
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the sensor (finisher media
entrance) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (finisher
media entrance).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to Step 4. Go to Step 3.
3
Check the sensor (finisher media
entrance) for proper connection.
Is the above component
properly connected?
Replace the sensor (finisher
media entrance).
Go to “Sensor (finisher media
entrance) removal” on
page 4-391.
Replace connections.
4
Check the finisher controller card
assembly for proper connection.
Is the above component
properly connected?
Go to Step 5. Replace connections.
5
POR the machine.
Does the error continue?
Replace the finisher controller
card assembly.
Go to “Finisher PCBA removal”
on page 4-353.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.