Lexmark X95 series - Waste Toner Auger Chute Removal

4-194 Service Manual
7558-xxx
Go Back
Previous
Next
15. Remove the three screws (H) securing the waste toner agitator motor to the machine.
16. Remove the waste toner agitator motor.
Waste toner auger chute removal
1. Remove the printer front door. See “Printer front door removal” on page 4-13.
2. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-178.
3. Remove the waste toner box.
4. Remove the four photoconductor units.
5. Remove the four toner supplies.
6. Remove the operator panel left cover. See “Operator panel left cover removal” on page 4-10.
7. Remove the operator panel right cover. See “Operator panel right cover removal” on page 4-11.
8. Remove the operator panel front cover. See “Operator panel front cover (MFP) removal” on page 4-8.
9. Remove the printhead retract door. See “Printhead retract door removal” on page 4-145.
10. Remove the inner cover. See “Inner cover removal” on page 4-4.
11. Remove the ATC sensor PCB bracket. See “ATC sensor PCB bracket removal” on page 4-29.
12. Remove the three screws (A) from the waste toner auger chute.
A