Lexmark X95 series - Sensor (ADF Feed Out) Late Jam; Go Back

2-138 Service Manual
7558-xxx
Go Back
Previous
Next
281.03 Sensor (ADF feed out) late jam
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the ADF rollers for wear.
Is the ADF feed/pick roller
assembly or the ADF
separation roller guide
assembly free of excess wear?
Go to step 3. Clean or replace the ADF feed/
pick roller assembly. Go to “ADF
feed/pick roller assembly
removal” on page 4-210, or
“ADF separation roller guide
removal” on page 4-223.
3
Check the sensor (ADF feed out)
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch ADF/SCANNER
SENSOR TESTS.
4. Touch Sensor (ADF feed
out).
Does the display on the
operator panel change every
time the sensor actuator is
operated?
Go to step 5. Go to step 4.
4 Check the sensor (ADF feed out)
for proper connection.
Is the above component
properly connected?
Replace the sensor (ADF feed
out).
Go to “Sensor (ADF feedout)
removal” on page 4-243.
Replace the connections.
5 Check the ADF feed motor for
proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch ADF/SCANNER
MOTOR TESTS.
4. Touch ADF feed motor
(forward).
5. Touch ADF feed motor
(reverse).
Does the motor rotate
normally?
Go to step 7. Go to step 6.
6 Check the ADF feed motor for
proper connection.
Is the above component
properly connected?
Replace the ADF feed motor. Go
to “ADF feed motor removal”
on page 4-209.
Replace the connections.