Lexmark X95 series - Sensor (Booklet Compiler Media Present) Error

2-208 Service Manual
7558-xxx
Go Back
Previous
Next
381.40 Sensor (booklet compiler media present) error
3
Check the main connector on the
booklet unit sensor interface
cable assembly.
Is the above component free of
damage?
Go to step 4. Replace the booklet sensor
interface cable assembly.
4
Check the main connector on the
booklet unit motor interface cable
assembly.
Is the above component free of
damage?
Go to step 5. Replace the booklet motor
interface cable assembly.
5
Check the booklet stapler
interface cable assembly.
Is the above component free of
damage?
Go to step 6. Replace the booklet stapler
interface cable assembly.
6
Check the connector on the back
of the booklet stapler unit
assembly.
Is the above component free of
damage.
Replace the booklet folding/exit
drive motor assembly. Go to
“Booklet folding/exit drive
motor assembly removal” on
page 4-326.
Go to step 7.
7
Perform a print test booklet
stapled document.
Does the error remain?
Replace the booklet controller
card assembly. Go to “Booklet
controller card assembly
removal” on page 4-322.
Problem resolved
8
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the finisher controller
PCBA. Go to “Finisher PCBA
removal” on page 4-353.
Problem resolved
Step Action and questions Yes No
1 Check the booklet unit interface
connector assembly.
Is the above component free of
damage?
Go to step 2. Replace the booklet unit interface
connector assembly.
2
Check the main connector on the
booklet unit sensor interface
cable assembly.
Is the above component free of
damage?
Go to step 3. Replace the booklet unit sensor
interface cable assembly.
3
Check the main connector on the
booklet unit motor interface cable
assembly.
Is the above component free of
damage?
Go to step 4. Replace the booklet unit motor
interface cable assembly.
Step Action and questions Yes No