Lexmark X95 series - Sensor (Booklet End Guide HP) Removal; Sensor (Booklet Front Tamper HP) Removal

Repair information 4-383
7558-xxx
Go Back
Previous
Next
Sensor (booklet end guide HP) removal
1. Remove the booklet unit assembly. See “Booklet unit chassis removal” on page 4-335.
2. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-334.
3. Disconnect the connector from the sensor (booklet end guide HP) (A).
4. Release the hooks securing the sensor (booklet end guide HP) (A) from the booklet unit.
5. Remove sensor (booklet end guide HP) (A).
Sensor (booklet front tamper HP) removal
1. Remove the booklet unit assembly. See “Booklet unit chassis removal” on page 4-335.
2. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-334.
3. Disconnect the connector from the booklet front tamper sensor.
4. Remove the screw securing the sensor (booklet front tamper HP) bracket from the booklet unit assembly.
Connector
A
Left