Lexmark X95 series - Configuration Menu; Entering Configuration Menu; Available Settings

3-6 Service Manual
7558-xxx
Go Back
Previous
Next
Configuration Menu
Entering Configuration Menu
1. Turn off the printer.
2. Press and hold the 2 and 6 buttons simultaneously.
3. Turn on the printer.
4. Release the buttons after 10 seconds.
Available settings
Settings appear on the LCD in the order shown:
Reset Separator Roll and Pick
Assembly Counter
See “Reset Separator Roll and Pick Assembly Counter”
on page 3-14.
Reset Maintenance Counter
See “Reset Maintenance Counter Value” on page 3-14.
REGISTRATION
See “REGISTRATION” on page 3-13.
USB Scan to Local
See “USB Scan to Local” on page 3-16.
Black Only Mode
See “Black Only Mode” on page 3-8.
Print Quality Pages
See “Print Quality Pages” on page 3-13.
Reports
See “Reports” on page 3-14.
Color Trapping
See “Color Trapping” on page 3-9.
Tray Insert Msg
See “Tray Insert Message Delay” on page 3-15.
SIZE SENSING
See “Size Sensing” on page 3-15.
Exit Tray 2
See “Exit Tray 2” on page 3-10.
Panel Menus
See “Panel Menus” on page 3-13.
PPDS Emulation
See “PPDS Emulation” on page 3-13.
Download Emuls
Factory Defaults
See “Factory Defaults” on page 3-10.
Energy Conserve
See “Energy Conserve” on page 3-9.
Fax Low Power Support
See “Fax Low Power Support” on page 3-10.
Min Copy Memory
See “Min Copy Memory” on page 3-12.
NumPad Job Assist
See “NumPad Job Assist” on page 3-12.
Format Fax Storage
See “Format Fax Storage” on page 3-11.
Fax Storage Location
See “Fax Storage Location” on page 3-11.
Auto Align Adj
See “Automatic Alignment Adjust Calibration” on
page 3-8.
ADF Edge Erase
See “ADF Edge Erase” on page 3-8.
FB Edge Erase
See “FB Edge Erase” on page 3-11.