Lexmark X95 series - Stepper Motor (Exit) Assembly and Belt (Exit) Removal

Repair information 4-417
7558-xxx
Go Back
Previous
Next
5. Remove the two screws securing the bracket (D) to the finisher.
6. Remove the bracket (D).
7. Remove the two screws securing the bracket (D) to the stepper motor (entrance/paddle) (C).
8. Remove the stepper motor (entrance/paddle) (C).
9. Remove the belt (entrance/paddle) (B).
Reinstallation notes:
•
The tension of the belt (entrance/paddle) (B) is automatically adjusted by the force of the spring attached to
the belt tensioner bracket (A).
• Tighten the two screws in the order shown.
Stepper motor (exit) assembly and belt (exit) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
2. Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move it down as shown.
3. Remove the belt (exit) (B) from the stepper motor (exit) (C).
D
C
Connector