2-240 Service Manual
7558-xxx
841.00 Image pipeline ASIC failure
5
Check the booklet fold solenoid
for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Booklet knife
solenoid.
Does the above component
operate properly?
Go to step 7. Go to step 6.
6
Check the booklet fold solenoid
for proper connection.
Is the above component
properly connected?
Replace the booklet fold
solenoid. Go to “Booklet fold
solenoid removal” on
page 4-325.
Replace the connection.
7
Check the booklet controller card
assembly for proper connection.
Is the above component
properly connected?
Replace the booklet controller
card assembly).
Go to “Booklet controller card
assembly removal” on
page 4-322.
If the error remains, then go to
step 8.
Replace the connections.
8
Check the finisher controller
PCBA for proper connection.
Is the above component
properly connected?
Go to step 9. Replace the connections.
9
POR the machine.
Does the error continue?
Replace the finisher controller
PCBA.
Go to “Finisher PCBA removal”
on page 4-353.
Problem resolved
Step Action and questions Yes No
1 Perform a POR.
Does the error occur when the
power is turned off/on?
Go to step 2. Perform several print tests.
If the problem remains, then go to
step 2.
2
Turn the printer off for 60
seconds.
Does the error occur when the
power is turned off/on again?
Replace the RIP card assembly.
Go to “RIP PCBA removal” on
page 4-150.
Problem resolved
Step Action and questions Yes No
To Next Page
Loading...
