Lexmark X95 series - Too Short Size Jam; Too Long Size Jam

2-168 Service Manual
7558-xxx
Go Back
Previous
Next
295.03 Too short size jam
295.04 Too long size jam
Step Action and questions Yes No
1 Check the document size.
Is the correct size document
being inserted into the ADF?
Go to step 2. Insert the proper size document
into the ADF.
2
Check the sensor (ADF pre
registration), sensor (ADF feed
out), and ADF controller PCBA
for proper connection.
Are the above components
properly connected?
Go to step 3. Replace the connections.
3
Place an undamaged document
in the ADF, and perform an ADF
test.
Does the error remain?
Replace the ADF controller
PCBA.
Go to “ADF controller PCBA
removal” on page 4-203.
Go to step 4.
Problem resolved
4
Place an undamaged document
in the ADF, and perform an ADF
test.
Does the error remain?
Replace the RIP PCBA.
Go to “RIP PCBA removal” on
page 4-150.
Problem resolved
Step Action and questions Yes No
1 Check the document size.
Is the correct size document
being inserted into the ADF?
Go to step 2. Insert the proper size document
into the ADF.
2
Check the sensor (ADF pre
registration), sensor (ADF feed
out), and ADF controller PCBA
for proper connection.
Are the above components
properly connected?
Go to step 3. Replace the connections.
3
Place an undamaged document
in the ADF, and perform an ADF
test.
Does the error remain?
Replace the ADF controller
PCBA.
Go to “ADF controller PCBA
removal” on page 4-203.
Go to step 4.
Problem resolved
4
Place an undamaged document
in the ADF, and perform an ADF
test.
Does the error remain?
Replace the RIP PCBA.
Go to “RIP PCBA removal” on
page 4-150.
Problem resolved