Lexmark X95 series - Media Eject Unit Assembly Removal

4-370 Service Manual
7558-xxx
Go Back
Previous
Next
5. Remove the three screws securing the media eject motor assembly (A).
6. Remove the media eject motor assembly (A).
7. Remove any remaining harnesses from the clamps.
Media eject unit assembly removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-348.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
3. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-422.
4. Remove the upper media bin vertical cover. See “Right eject cover removal” on page 4-381.
5. Remove the two media eject unit springs (A) by pushing them downward.
6. Disconnect the connector from the eject unit solenoid (B).
7. Release the harness from the two clamps.
A
Rear
Connector
Harness clamp
Right
B
A
A
Connector