Lexmark X95 series - Sensor (Booklet End Guide HP) Lag Jam

Diagnostic information 2-197
7558-xxx
Go Back
Previous
Next
381.32 Sensor (booklet end guide HP) lag jam
7
Check the booklet front tamper
motor for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Booklet tamper front
motor (reverse).
5. Touch Booklet tamper front
motor (reverse).
Does the above component
operate properly?
Go to step 6. Go to step 5.
8
Is the booklet front tamper
motor properly connected?
Replace the booklet front tamper
motor. Go to “Booklet front
tamper motor removal” on
page 4-327.
Replace the connection.
9
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the booklet controller
card assembly. Go to “Booklet
controller card assembly
removal” on page 4-322.
Problem resolved
10
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the finisher controller
PCBA. Go to “Finisher PCBA
removal” on page 4-353.
Problem resolved
Step Action and questions Yes No
1 Check the booklet unit interface
connector assembly.
Is the above component free of
damage?
Go to step 2. Replace the booklet unit interface
contact.
2
Check the main connector on the
booklet unit sensor interface
cable assembly.
Is the above component free of
damage?
Go to step 3. Replace the booklet sensor
interface cable assembly.
3
Check the main connector on the
booklet unit motor interface cable
assembly.
Is the above component free of
damage?
Go to step 4. Replace the booklet motor
interface cable assembly.
Step Action and questions Yes No