Lexmark X95 series - Finisher LVPS PCBA Removal

Repair information 4-351
7558-xxx
Go Back
Previous
Next
• Make sure the bin bracket (C) is level to prevent binding.
Finisher LVPS PCBA removal
1. Remove the right lower cover. See “Upper media bin front cover removal” on page 4-423.
2. Disconnect all the connectors from the finisher LVPS PCBA (A).
3. Remove the two screws securing the finisher LVPS PCBA (A) to the finisher.
4. Remove the finisher LVPS PCBA (A).
Front
G
F
E
D
C
H
Rear
A