Repair information 4-403
7558-xxx
5. Release the hooks securing the sensor to the bracket (B).
6. Remove the sensor (stacker bin level encoder) (A).
Sensor (stacker bin upper limit) or sensor (stacker bin no media) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
2. Remove the rear lower cover. See “Upper media bin front cover removal” on page 4-423.
3. Remove the stacker media bin assembly. See “High capacity feeder (HCF) removal procedures” on
page 4-429.
4. Remove the stacker bin lift motor assembly. See “Stacker bin lift motor assembly removal” on
page 4-407.
5. Remove the four screws securing the metal cover (A) to the finisher.
6. Remove the metal cover (A).
7. Disconnect the connector from the sensor (stacker bin upper limit) (B) or the sensor (stacker bin no
media) (C).
8. Release the hooks of the selected sensor.
To Next Page
Loading...
