Lexmark X95 series - HCF Sensor (Tray 5 Feedout) Removal

Repair information 4-443
7558-xxx
Go Back
Previous
Next
6. Remove the sensor (HCF media tray set) (A).
HCF sensor (tray 5 feedout) removal
1. Remove the HCF unit from the printer.
2. Open the HCF top door assembly.
3. Remove the two screws securing the bracket (B) to the unit.
4. Remove the bracket (B).
5. Disconnect the connector from the sensor (tray 5 feedout) (A).
6. Release the hooks securing the sensor (tray 5 feedout) (A) to the bracket (B).
A
Front
Connector