Lexmark X95 series - Tray Module Tray 2 Media Turn Guide Removal; Tray Module Upper Transport Motor Removal

Repair information 4-287
7558-xxx
Go Back
Previous
Next
Tray module tray 2 media turn guide removal
1. Open the left door.
2. Gently press the lower edges of the tray module 2 media turn guide.
3. Remove the tray module 2 media turn guide from the machine.
Tray module upper transport motor removal
This removal procedure is not applicable to TTM tray modules.
1. Remove the tray module rear cover. See “Tray module rear cover removal” on page 4-284.
2. Disconnect the cable (A).
3. Release the harness from the clamp (B).