Lexmark X95 series - Bridge Drive Motor Removal

Repair information 4-303
7558-xxx
Go Back
Previous
Next
4. Remove the two screws (A) securing the bridge decurler top cover to the machine.
5. Remove the bridge decurler top cover.
Bridge drive motor removal
1. Remove the bridge unit assembly. See “Bridge unit assembly removal” on page 4-305.
2. Remove the bridge decurler rear cover. See “Bridge decurler rear cover removal” on page 4-301.
3. Remove the bridge unit right cover. See “Bridge decurler right cover removal” on page 4-302.
4. Remove the four screws (A) securing the bridge drive motor to the machine.