Lexmark X95 series - Fuser Assembly Removal; Fuser Cooling Fan Removal

4-84 Service Manual
7558-xxx
Go Back
Previous
Next
Fuser assembly removal
This removal procedure applies to the100V, 110V, and 220V fuser assemblies.
1. Open the printer left duplex door assembly.
2. Remove the two thumbscrews (A).
3. Use the handles (B) to pull the fuser assembly out of the machine.
Fuser cooling fan removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-19.
2. Disconnect the input option cable (A).