Lexmark X95 series - Sensor (Booklet Media Exit) Lag Jam

Diagnostic information 2-239
7558-xxx
Go Back
Previous
Next
493.05 Sensor (booklet media exit) lag jam
8
POR the machine.
Does the error continue?
Replace the finisher controller
PCBA.
Go to “Finisher PCBA removal”
on page 4-353.
Problem resolved
Step Action and questions Yes No
1 Check the sensor (booklet media
exit) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (booklet
media exit).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 3. Go to step 2.
2
Check the sensor (booklet media
exit) for proper connection.
Is the above component
properly connected?
Replace the sensor (booklet
media exit)
Go to “Sensor (booklet unit
media exit) removal” on
page 4-388.
Replace connections.
3
Check the booklet folding/exit
motor for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Booklet folding/exit
motor (forward).
5. Touch Booklet folding/exit
motor (reverse).
Does the above component
operate properly?
Go to step 5. Go to step 4.
4
Check the booklet folding/exit
motor for proper connection.
Is the above component
properly connected?
Replace the booklet folding/exit
motor.
Go to “Booklet folding/exit
drive motor assembly removal”
on page 4-326.
Replace connections.
Step Action and questions Yes No