3-12 Service Manual
7558-xxx
Key Repeat Initial Delay
The value of this setting determines the initial length of delay before a key could repeat.
To change this setting:
1. From the Configuration Menu, navigate to Key Repeat Initial Delay.
2. Touch or to change the value.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Key Repeat Rate
The value of this setting determines the number of repeating key presses allowed per second.
To change this setting:
1. From the Configuration Menu, navigate to Key Repeat Rate.
2. Touch or to change the value.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
Min Copy Memory
The Interrupt process automatically pauses the printing of jobs in the “normal” print queue and instead prints the
copy jobs that exist in a priority queue until that queue is empty; thereafter the device resumes printing the jobs
in the “normal” print queue. Interrupt is activated by default but may be turned off through the configuration
pages.
The value of this setting determines how much DRAM the device will allot to storing the copy jobs in the priority
queue.
To change this setting:
1. From the Configuration Menu, navigate to Min Copy Memory.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
NumPad Job Assist
This setting determines if a user can configure and initiate a job using the panel’s hard buttons. When activated,
a user can choose a function like Copy, or Fax, enter specific values for a limited number of settings, and initiate
the job with a series of key presses.
To change this setting:
1. From the Configuration Menu, navigate to NumPad Job Assist.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
To Next Page
Loading...
