Lexmark X95 series - Controller Communication Failure; IM Logic Failure; RIP Card Assembly NVRAM Failure

2-256 Service Manual
7558-xxx
Go Back
Previous
Next
940.03 Controller communication failure
940.04 IM logic failure
951.xx RIP card assembly NVRAM failure
2
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Go to step 3.
Problem resolved
3
POR the machine.
Does the error continue?
Replace the lower printer engine
PCBA.
Go to “Lower engine PCBA
removal” on page 4-104.
Problem resolved
Step Action and questions Yes No
1 Check the bridge controller PCBA
connections.
Are the above connections
properly connected and not
damaged?
Go to step 2. Connect the components
properly and replace damaged
connections.
2
Replace the bridge PCBA. Go to
“Bridge PCBA removal” on
page 4-32.
Does the error remain?
Go to step 3. Problem resolved
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Install the correct firmware.
Does the problem persist?
Go to step 2. Problem resolved
2
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Perform a POR.
Does the error occur when the
power is turned off/on?
Go to step 2. Perform several print tests.
If the problem remains, then go to
step 2.
Step Action and questions Yes No