Lexmark X95 series - Action for Prompts

Diagnostic aids 3-7
7558-xxx
Go Back
Previous
Next
Action for prompts
This setting enables users to determine which input source would receive paper-related or envelope-related
change prompts when they occurred. Regardless of the target source, the device always requires some type of
user assistance to resolve the change prompt (examples: pushing a button to ignore the prompt and changing
the source’s installed media). However, this setting gives a user the option of having the device resolve change
prompt situations without requiring any user assistance.
To change this setting:
1. From the Configuration Menu, navigate to Action for prompts.
2. Touch or to change the setting.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.
When set to Prompt user, the device behaves like the past implementation. When a change prompt occurs, the
device stops printing, posts the change prompt to the target source, and waits for the user to select an action
before continuing.
When set to Continue, the device automatically assumes that the user selects Continue every time a change
prompt is encountered. Likewise, when the device is set to Use Current, all change prompts will perform as if
Use Current was selected by the user.
Disable Scanner
See “Disable Scanner” on page 3-9.
Paper Prompts
See “Paper Prompts” on page 3-13.
Envelope Prompts
See “Envelope Prompts” on page 3-9.
Action for Prompts
See “Action for prompts” on page 3-7.
Jobs On Disk
See “Jobs on Disk” on page 3-11.
Disk Encryption
See “Disk Encryption” on page 3-9.
Erase All Information on Disk
See “Erase all Information on Disk” on page 3-10.
Wipe All Settings
See “Wipe All Settings” on page 3-16.
Font Sharpening
See “Font Sharpening” on page 3-11.
Require Standby
See “Require Standby” on page 3-14.
Short-edge Printing
See “Short-edge Printing” on page 3-14.
UI Automation
See “UI Automation” on page 3-15.
Key Repeat Initial Delay
See “Key Repeat Initial Delay” on page 3-12.
Key Repeat Rate
See “Key Repeat Rate” on page 3-12.
Clear Custom Status
See “Clear Custom Status” on page 3-8.
USB Speed
See “USB Speed” on page 3-16.
Automatically Display Error Screens
See “Automatically Display Error Screens” on page 3-8.
Booklet Adjustments
See “Booklet Adjustments” on page 3-8.
Exit Config Menu