Lexmark X95 series - Input Tray Tests; Feed Tests (Input Tray); Next; Motor Tests

Diagnostic aids 3-23
7558-xxx
Go Back
Previous
Next
INPUT TRAY TESTS
Feed Tests (Input Tray)
This test is used to observe the paper path of media as it passes through the printer. To observe the paper path,
a user can open the upper rear door while this test executes. No information is printed on the feed test pages
since the printhead LED isn’t engaged during this test.
To run this test:
1. From the Diagnostics Menu, navigate to INPUT TRAY TESTS.
2. Select the appropriate input source from the following choices:
• Tray 1
• Tray 2
• Tray 3
• Tray 4
• Multi-Purpose Feeder
3. Touch either Single or Continuous.
• Single—Feeds one sheet of media from the selected source.
• Continuous—Media continues feeding from the selected source until Stop is pressed.
MOTOR TESTS
PRINTER MOTOR TESTS
To run these tests:
1. From the Diagnostics Menu, navigate to MOTOR TESTS.
2. Select PRINTER MOTOR TESTS.
3. Select the test from the following options:
Available printer motor tests:
• Fuser/lower redrive/1st transfer
retract motor
• Printer transport motor
• Registration motor • HCF feed/lift motor (feed)
• Tray 1 feed/lift motor (feed) • HCF feed/lift motor (lift)
• Tray 1 feed/lift motor (lift) • HCF transport motor
• Tray 2 feed/lift motor (feed) • KCMY drum & transfer belt motor
• Tray 2 feed/lift motor (lift) • Y erase lamp
• Tray 3 feed/lift motor (feed) • M erase lamp
• Tray 3 feed/lift motor (lift) • C erase lamp
• Tray 4 feed/lift motor (feed) • K erase lamp
• Tray 4 feed/lift motor (lift) • Waste toner agitator motor
• MPF feed/lift motor (feed) • Image density sensor shutter open
• MPF feed/lift motor (pick) • Image density sensor shutter close
• Registration clutch • Y toner dispense motor
• Upper redrive diverter gate • M toner dispense motor
• Duplex motor (reverse) • C toner dispense motor
• Upper redrive motor (forward) • K toner dispense motor
• Upper redrive motor (reverse) • Developer motor
• Lower redrive shift motor (forward) • Transfer belt motor
• Lower redrive shift motor (reverse) • 1st transfer rollers retract motor (contacted)