Lexmark X95 series - Tray Module Lower Transport Motor Removal

4-280 Service Manual
7558-xxx
Go Back
Previous
Next
3. Remove the foot cover.
4. Remove the two screws (B).
Note: Opening the tray module left door will help you remove the tray module left cover.
5. Remove the tray module left cover.
Tray module lower transport motor removal
This removal procedure is not applicable to TTM tray modules.
1. Remove the tray module rear cover. See “Tray module rear cover removal” on page 4-284.
2. Disconnect the cable (A).
3. Release the harness from the clamp (B).