Lexmark X95 series - HCF Media out Actuator Removal

Repair information 4-435
7558-xxx
Go Back
Previous
Next
3. Lift the media long edge guide assembly (A) upward to release it from the hinges on the HCF media tray.
4. Remove the media long edge guide assembly (A).
Note: With the media long edge guide assembly (A) removed, the wave washer (B) becomes detached.
HCF media out actuator removal
1. Open the HCF top door.
2. Open the HCF feed unit assembly.
3. Remove the e-clip securing the media out actuator (A) to the HCF media feed unit assembly (B).
E-clip
B
A