Lexmark X95 series - HCF Separation Roll Assembly Removal

Repair information 4-445
7558-xxx
Go Back
Previous
Next
9. Remove the separation gear - 25 tooth (F).
HCF separation roll assembly removal
1. Open the HCF top door.
2. Open the HCF feed unit assembly.
3. Push the two ends of the HCF separation roll assembly (A) inward, and move it upward in the direction of
the arrow to release it from the HCF media feed unit assembly (B).
4. Remove the HCF separation roll assembly (A).
Note: When removing the HCF separation roll assembly (A), do not touch the rubber surface.
Note: Before re-installing the HCF separation roll assembly (A), do not touch the rubber surface.
E-clip
A
B
C
D
E
F
Front
B
A