Lexmark X95 series - Punch Carriage Assembly Removal

Repair information 4-375
7558-xxx
Go Back
Previous
Next
• Tighten the two screws in the order shown.
Punch carriage assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
3. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-422.
4. Remove the connector from the sensor (punch carriage shift HP) (A).
5. Remove the top cover. See “Top cover removal” on page 4-421.
6. Release the harness from the punch carriage assembly (B).
7. Remove the connector from the punch carriage shift motor assembly (C).
8. Release the two punch unit assembly harnesses from the three clamps on the rear of the finisher.
9. Disconnect the two punch unit assembly harnesses from the main harness.
10. Remove the screw securing the grounding wire (D) to the punch unit carriage assembly (B).
Rear
B
C
E
D
F
Rear
DTighten
second
Tighten first