Lexmark X95 series - HCF Transport Motor Removal; HCF Transport Roller Kit Removal

Repair information 4-449
7558-xxx
Go Back
Previous
Next
HCF transport motor removal
1. Remove the HCF unit from the printer.
2. Remove the HCF rear cover. See “HCF rear cover removal” on page 4-441.
3. Disconnect the connector from the HCF transport motor (A).
4. Release the harness from the clamp.
5. Remove the three screws securing the HCF transport motor (A) to the unit.
6. Remove the HCF transport motor (A).
HCF transport roller kit removal
1. Remove the HCF unit from the printer.
2. Use needle nose pliers to remove the e-clip on the front side securing the HCF transport roller kit (A) to the
unit.
A
Harness clamp
Connector