Diagnostic aids 3-27
7558-xxx
REPORTS
This menu contains informational reports that are helpful when servicing a device.
The Menu Settings Page report generates a list of the Diagnostic Menu settings and each setting’s current
value.
SCANNER TESTS
ASIC Test
This setting initiates a scan of the scanner ASIC’s memory.
Feed Test (SCANNER TESTS)
This setting enables a user to execute a continuous feed test from either the ADF or the flatbed.
To perform the Feed Test:
1. Touch SCANNER TESTS from the Diagnostics Menu.
2. Touch Feed Test.
You are prompted to select a paper size for the ADF. For flatbed scans, the full length of the flatbed is traversed.
The device decides whether to run the flatbed or the ADF according to the following flowchart:
During the test, Running... Flatbed:xxxxx ADF:xxxxx appears on the LCD. The Flatbed number increases
each time the scanner performs a flatbed scan, and the ADF number increases each time the scanner performs
an ADF scan.
Press Stop to end this test.
If an error occurs (such as a scanner jam), Feed Test Failed Flatbed:xxxxx ADF:xxxxx appears on the LCD.
To clear the message, press Stop.
Paper
in
ADF?
Scan the full
length of the
flatbed.
Scan all pages
from the ADF,
assuring selected
paper size.
No
Yes
To Next Page
Loading...
