Lexmark X95 series - Sensor (Media on Belt) Late Jam

Diagnostic information 2-99
7558-xxx
Go Back
Previous
Next
201.03 Sensor (media on belt) late jam
3
Check the sensor (media on belt)
for proper connection.
Is the above component
properly connected?
Replace the sensor (media on
belt).
Go to “Sensor (media on belt)
removal” on page 4-155.
Replace the connection.
4
Perform a print test. Go to
“PRINT TESTS” on page 3-25.
Does the error continue?
Replace the lower engine PCBA.
Go to “Lower engine PCBA
removal” on page 4-104.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the sensor (media on belt )
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch PRINTER SENSOR
TESTS.
4. Touch Sensor (paper on
belt).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 4. Go to step 3.
3
Check the sensor (media on belt)
for proper connection.
Is the above component
properly connected?
Replace the sensor (media on
belt).
Go to “Sensor (media on belt)
removal” on page 4-155.
Replace the connection.
4
Check the registration drive
motor assembly for proper
operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch PRINTER MOTOR
TESTS.
4. Touch Registration motor.
Does the above component
operate properly?
Go to step 6. Go to step 5.
Step Action and questions Yes No