Lexmark X95 series - HCF Rear Cover Removal; HCF Sensor (HCF Media Size) Removal

Repair information 4-441
7558-xxx
Go Back
Previous
Next
HCF rear cover removal
1. Remove the four screws securing the HCF rear cover (A) to the unit.
2. Remove the HCF rear cover (A).
HCF sensor (HCF media size) removal
Note: This procedure can be applied to HCF sensor (media size L) and the HCF sensor (media size R).
1. Remove the HCF media tray. See “HCF media tray assembly removal” on page 4-436.
2. Remove the HCF top cover. See “HCF top cover removal” on page 4-446.
3. Remove the HCF rear cover. See “HCF rear cover removal” on page 4-441.
4. Disconnect the connector from the sensor (HCF media size R) (A) or the sensor (HCF media size L) (B).
5. Release the hooks securing the sensor (HCF media size R) (A) or the sensor (HCF media size L) (B) to the
unit.
A