Lexmark X95 series - Sensor (Tray 5 Pre Feed) Removal

Repair information 4-455
7558-xxx
Go Back
Previous
Next
5. Remove the sensor (tray 5 media out) (A).
Note: The sensor (tray 5 media out) (A) may be easier to replace if the upper guide (C) is removed to
provide access.
Sensor (tray 5 pre feed) removal
1. Open the HCF top door.
2. Open the HCF feed unit assembly.
3. Remove the three screws securing the upper guide (A) to the HCF feed unit assembly (B).
4. Remove the upper guide (A).
5. Remove the connector from the sensor (tray 5 pre-feed) (C).
6. Remove the one screw securing the sensor (tray 5 pre feed) (C) to the HCF feed unit assembly (B).
A
C
Front
B
Connector