214323 201 Revision A
Figure 3.341: John Deere S7 Display – Header
Calibration
9. Select CALIBRATE (A) at bottom of page. The
calibration overview window opens.
Figure 3.342: John Deere S7 Console
10. Press button (A) on console to set engine to high idle.
Figure 3.343: John Deere S7 Display – Header
Calibration
11. Select START on calibration overview page.
12. Follow instructions that appear on combine display. As
you proceed through calibration process, display will
automatically update to show next step.
NOTE:
If an error code appears during calibration, sensor is out
of voltage range and will require adjustment. Refer to
Adjusting Voltage Limits, page 105.
OPERATION
To Next Page
Loading...
