215916 147 Revision A
WARNING
NEVER operate the engine in an enclosed building. Proper ventilation is required to prevent exhaust gas hazards.
WARNING
When working with batteries, remove any worn metal jewelry. NEVER allow a metal object (such as a wrench) to touch
across the battery terminals. A short circuit can produce an extremely hot spark, which can cause severe injuries.
1. Retract all cylinders to protect the cylinder rods from corrosion during storage, including:
• Header lift cylinders
• Float cylinders
• Header tilt cylinder
2. Check for broken components and order replacements from your Dealer. Attending to these items right away will save
time and effort at the beginning of the next season.
3. Tighten loose hardware and replace any missing hardware. Refer to 8.1 Torque Specifications, page 501.
4. Clean the windrower thoroughly.
5. Repaint all worn or chipped painted surfaces to prevent rust.
6. Fill the fuel tank to prevent condensation.
7. When storing for 6 MONTHS OR LONGER, drain the diesel exhaust fluid (DEF) tank. For instructions, refer to Draining
Diesel Exhaust Fluid Tank, page 341.
8. Change the oil to remove acids and other by-products of combustion from the engine.
9. Test the engine coolant antifreeze concentration to ensure it is sufficient to protect the engine against the lowest
expected temperature.
10. Drain the windshield washer tank or ensure the fluid can endure the lowest expected temperatures.
11. Lubricate the windrower thoroughly, leaving excess grease on fittings to keep moisture out of bearings. Apply grease to
the exposed threads and the sliding surfaces of components.
12. Remove the batteries. For instructions, refer to Removing Battery, page 432. Bring the batteries to full charge, and
store in a cool, dry place not subject to freezing.
13. If possible, block up the windrower to take weight off the tires. If this is not possible, increase the tire pressure by 25%
for storage. Adjust to recommended operating pressure before next use.
IMPORTANT:
Do NOT exceed the maximum pressure specified on the tire sidewall.
14. Store the windrower in a dry, protected place.
15. If stored outside, seal the air cleaner intake and exhaust pipe with plastic bags and/or waterproof tape.
16. If stored outside, cover the windrower with a breathable cover. Avoid plastic covers that can trap humidity.
OPERATION
To Next Page
Loading...
