ND-70348 (E) CHAPTER 4
Page 339
Revision 3.0
AKYD
10. There is no default key data provided for D
term
(8-button type). The key data for all the line/feature buttons
must be programmed. When assigning the key data of the line/feature button, take the following precau-
tions:
(a) My Line Key must be assigned in KYN=1-8, and KYN=9-16 should be assigned KYI=0 (Not used).
(b) The following function keys are basically fixed:
FKY=13:CONF (Three-Way Calling)
FKY=18:TRANSFER (Call Transfer-All Calls)
FKY=20:HOLD (Non-Exclusive Hold/Exclusive Hold)
FKY=28:ANSWER
FKY=51:MIC
FKY=52:SPEAKER
FKY=57:RECALL
(c) Not used line/feature buttons should be assigned KYI=0 (Not used).
11. There is no default key data provided for D
term
(24-button type/32-button type). The key data for all of the
line/feature buttons must be programmed. When assigning the key data of the line/feature button, take the
following precautions:
(a) My Line Key must be assigned in KYN=1-24, and KYN=25-40 should be assigned KYI=0 (Not used).
My Line in KYN=17-24 cannot be assigned without assigning any Line Key or any Function Key in
KYN=1-16.
(b) The following function keys are basically fixed.
FKY=13: CONF (Three-Way Calling)
FKY=18: TRANSFER (Call Transfer-All Calls)
FKY=20: HOLD (Non-Exclusive Hold/Exclusive Hold)
FKY=28: ANSWER
FKY=51: MIC
FKY=52: SPEAKER
FKY=57: RECALL
(c) Not used line/feature buttons should be assigned KYI=0 (Not used).
12. When using 16ELCJ (SP-3295, PROG-B or later) is used, the FKY=49: Speed Calling-One Touch can be
assigned to a Key Number (KYN) larger than 16. Note 1, Note 2
Note 1: Speed Calling-One Touch data can be saved by the BOSD command.
Note 2: A maximum of 16 Key Numbers (KYNs) in the consecutive order can be programmed for Speed Call-
ing-One Touch key.
13. For Call Forwarding-Busy Line and Call Forwarding-Don’t Answer, refer to ASYD SYS1 Index5 (sepa-
rate/common access for C.F.-Busy Line and C.F.-Don’t Answer). If common access codes are assigned,
only one key is required to activate the features. If separate access codes are assigned, separate function
keys must be assigned.
To Next Page
Loading...
Need help?
General