ND-70348 (E) CHAPTER 4
Page 340
Revision 3.0
AKYD
14. <D
term
65> The FKY=55: One-Touch changeover (PAGE) should be assigned when registering desti-
nation numbers greater than 20 as one-touch speed calling codes.
<D
term
75> The FKY=55: One-Touch changeover (PAGE) should be assigned when registering desti-
nation numbers greater than 16 as one-touch speed calling codes.
Note: Each one-touch button is assigned a 2-page memory (Page 0 and Page 1). One destination number can be
assigned on a page basis.
Therefore, when originating an outgoing call, the page of one-touch button can be designated by this
function key.
15. In conjunction with intercom service, take the following precautions:
(a) Before assigning the Intercom Key Data using this command, assign the Intercom Group Data using
the command AICD/ADIM.
(b) When providing the Intercom service, assign “The response priority when the SPEAKER button is
pressed or the station goes off-hook” by the parameter PRI. When not providing the Intercom service,
assign PRI=0.
16. When this command is used, the ELC card must be reinitialized (MB switch UP-DOWN).
17. A maximum number of 8 soft keys can be assigned via function key (FKY=122).
Note: 6 soft keys available at the maximum when page scroll key for soft key is displayed on the LCD.
18. Soft key data to be assigned by the function key (FKY=122) is not available for having the different func-
tion per each condition on the D
term
.
19. The same function data can not be assigned to both function key and soft key.
20. Expanded Multiple Line Operation-D
term
[E-26] service is available since Release 8 software enhancement
only when “KD=0 (Line)” is entered. This service is not available when “KD=1 (Intercom)” on “KD=2
(DSS Key)” is assigned.
To Next Page
Loading...
Need help?
General