ND-70348 (E) CHAPTER 4
Page 438
Revision 3.0
ALRNN
35 WINK
Width of a Wink Signal
0 = 160 msec. 1 = 64 msec.
2 = 96 msec. 3 = 128 msec.
4 = 160 msec. 5 = 192 msec.
6 = 224 msec. 7 = 265 msec.
8 = 288 msec. 9 = 320 msec.
10 = 352 msec. 11 = 384 msec.
12 = 416 msec. 13 = 448 msec.
14 = 480 msec. 15 = 512 msec.
Normally assign data
“0.”
36 VAD 0000Always assign data “0.”
37 CLD 0000Always assign data “0.”
38 FA
Forced Account/Forced Authorization Code
0 = Check is not required
1 = Check is required (For Remote Access to System)
39 BC
C.O Line Idle Balance Condition.
0 = Not balanced 1 = Balanced
For Australia only
40 TCM
Travel Class Mark
0 = Out of Service 1 = In Service
41 TDMQ
Tandem Off Hook OG Queuing
0 = Out of Service 1 = In Service
42 TRSC
Trunk Restriction class
0 = Out of Service 1-15= In Service
See AEFR command.
43 BT
Inter-office Busy Service
0 = Out of Service 1 = In Service
For CCIS voice route, as-
sign data “1.”
44 PRV
Line Trunk Privacy
0 = Privacy Out of Service
1 = Privacy In Service For Busy Verification, Call Wait-
ing, Executive Right of Way, Paging, Dictation, Data
Communication, etc.).
45 A/D
Analog/Digital Line Data
0 = Analog 1 = Digital
Assign data “1” only for
digital T1 routes or Bch
of ISDN routes.
46 CW
Call Waiting Service
0 = Out of Service 1 = In Service
47 TPQ
Priority OG Queuing
0 = Out of Service 1 = In Service
48 BL
Detection of Blocking Signal
0 = No detection 1 = Detection
49 TRKS
Trunk Selection Sequence
0 = Select from the trunk which becomes idle first.
1 = Select from the trunk which becomes idle last.
Assign this data revers-
ing to the mate office da-
ta. (Especially, for CCIS)
50 DPLY
Number Display of D
term
between offices
0 = Not given 1 = Given
For CCIS voice route and
ISDN Bch route.
LOGICAL ROUTE (LGRT) 1-899
REMARKSFUSION POINT CODE (FPC) 1-253
ROUTE NUMBER (RT) 1-255
To Next Page
Loading...
Need help?
General