ND-70348 (E) CHAPTER 4
Page 443
Revision 3.0
ALRNN
81 LPTM
Sender Inter-Digit Pause Index
0 = DP/1 sec., PB/0.5sec. 1 = 600 msec.
2 = 800 msec. 3 = 1000 msec.
4 = 1200 msec. 5 = 1400 msec.
6 = 1600 msec. 7 = 1800 msec.
8 = 2000 msec. 9 = 2200 msec.
10 = 2400 msec. 11 = 2600 msec.
12 = 2800 msec. 13 = 3000 msec.
14 = 3200 msec. 15 = 3400 msec.
(In case of MFC)
0 = 12.0 sec. 1 = 5.5 sec.
2 = 7.0 sec. 3 = 8.5 sec.
4 = 10.0 sec. 5 = 11.5 sec.
6 = 13.0 sec. 7 = 14.5 sec.
8 = 16.0 sec. 9 = 17.5 sec.
10 = 20.0 sec. 11 = 22.0 sec.
12 = 24.0 sec. 13 = 26.0 sec.
14 = 28.0 sec. 15 = 30.0 sec.
Note: Possible to use
when adjusting
the duration of
Pause in the
case of Speed
Calling System
or Adding dig-
its.
82 RSAX 0000Always assign data “0.”
83 CST 0000Always assign data “0.”
84 CSEG 0000Always assign data “0.”
85 CSEU 0000Always assign data “0.”
86 CSEL 0000Always assign data “0.”
87 CMP 0000Always assign data “0.”
88 TALK 0000Always assign data “0.”
89 FOT 0000Always assign data “0.”
90 RST 0000Always assign data “0.”
91 TOCI
Trunk Override Calling
0 = Override Inhibited (Calling side).
1 = Tie Line Override Service is provided (Calling side).
92 TOCD
Trunk Override Called
0 = Override Inhibited (Called side).
1 = Tie Line Override Service is provided (Called side).
93 ODGD 0000Always assign data “0.”
94 RLS 0000Always assign data “0.”
95 GWD
Gate Way Data Service
0= Out of Service 1 = Gate Way System
2-15= Not used
96 H1
ISDN H1 Switching
0 = – 1 = In Service
0000Always assign data “0.”
97 DT 0000
LOGICAL ROUTE (LGRT) 1-899
REMARKSFUSION POINT CODE (FPC) 1-253
ROUTE NUMBER (RT) 1-255
To Next Page
Loading...
Need help?
General